They provide an interface for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provide full-duplex (FDX) capability, which enables simultaneous transmission and reception of data on the network. The Ethernet controllers are integrated on the system board. The WAVE-594 and WAVE-694 appliance has two Ethernet connectors that are attached to the Ethernet controllers (see Figure 1-5). 100BASE-TX and 1000BASE-T Fast Ethernet standards require Category 5 or higher cabling. Statement 1021Ĭonnect a Category 3, 4, or 5 unshielded twisted-pair cable to an Ethernet connector. Some LAN and WAN ports both use RJ-45 connectors.

LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Warning To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. The WAVE appliance supports two Ethernet connectors and two Console ports on the front of the appliance.įigure 1-3 shows the back panel ports and connectors. Refer to the “Troubleshooting the System Hardware” chapter for more information. Table 1-2 describes the back panel LEDs and their functions.ĪC power is present, only standby output on. Note To monitor the boot process in normal operation, use a console port. Refer to the “Troubleshooting the System Hardware” chapter for more information.įigure 1-3 shows the back panel components. Power cord is not attached or power supply failure has occurred. Table 1-1 describes the front panel LEDs and their functions. This section contains the following topics:įigure 1-1 shows the front panel components. This section illustrates and describes the front and back panel controls, ports, and LED indicators on the WAVE-594 and WAVE-694. The WAVE-594 and WAVE-694 appliance supports Cisco Wide Area Application Services (WAAS) software version 4.4.1 and later releases. This chapter contains the following sections: This chapter provides a basic functional overview of the Cisco Wide Area Virtualization Engine 594 and 694 (WAVE-594 and WAVE-694) appliance and describes the hardware, major components, and front and back panel indicators and controls. Introducing the Cisco Wide Area Virtualization Engine 594 and 694

Tusb3410 eecode ser